SpamHash
|
aka SMTP, aka rfc2822
- Some problems associated with email...
- spam.
Solution to spam problem
- spamsum
How does this solve?
A spampot delivery point is known (assumed) to recieve 100% spam. All incoming messages to this mailbox are spamsum'd.
Then as a seperate filter, ALL incoming messages to anyone are spamsum checked against the database of messages generated by the spamsum scores. If the new message rates as "too similar", then it is also assumed to be spam, and dropped. bye bye.
Lexicon used here
- spamsum
- the program
- spamsum_scores
- the file listing spamsum scores
- spampot
- emails which were caught by being too similar to a pre-scored email
- spamsum cache
- archive of emails that generated the spamsum_scores file
- spampot cache
- archive of emails caught in the spampot.
Notes
- The spamsum_scores should be rotated. New scores are appended at the end, so approx a month of scores to be kept. (note however that this is a flat text file with no internal dates (would spamsum mind if dates are munged in as "not formatted correctly spamsum scores"?), so rotation would likely have to be performed in a "number of lines" manner. Say, 'keep the last 10,000 scores' and rotate daily.
- filtered messages should be kept for sanity checking
Pros
- spamsum is quick, saves message being filtered by heavier bayesian/etc filters
- dynamically reacts to new spam - so long as spampot is sufficiently knowledgable
Cons
- spampot address requires accepting messages we consider to be known spam
- requires totality of message to be accepted
Results
- SMTP Phase
- post-DATA
- CPU Use
- relatively low (significantly lower than, for eg, than any bayesian)
- Memory Use
- low (assumed)
- False Positives
- low (assuming the spampot used to collect spamsum scores isn't corrupted by ham (eg: mailing lists, or email memes)
- Maintenance
- low
- Effectiveness
- good (95% capture rate observed after only 8 hours of testing)
Testing
Some email addresses known to recieve spam were directed into the spamsum spampot and self-filtered (the procmail config below). After approx an hour, the spampot cache (emails filtered due to matching emails which were previously spamsummed (and saved to a spamsum cache)) was already at 1:1 ratio of messages with the spamsum cache. After 8 hours spamsum:spampot was 1:2.5. That is, we've caught 10 messages for every 4 we have spamsummed. That number dates back to the 'ignorant' spamsum_scores file (ie, empty), and the most recent mails are in fact running at a 1:20 ratio (95% effective). I expect the ratio to improve further as a larger spamsum history is saved (I aim for a spamsum history approx 100 times what I had after 8 hours (ie, approx 1 month or 10,000 messages))
Remember however that this is on a mailbox which is assumed to be recieving 100% spam - so the possibility of false positives is not being tested.
Configuration
My .procmailrc file within my spampot address
# all mail to this user is assumed to be spam. Nothing legit comes here.
# ...thus, generate a spamsum score on EVERYTHING
SHELL=/bin/sh
DROPPRIVS=yes
VERBOSE=on
LOGFILE=emailtmp/procmail.log
# (this comes first so spampot messages aren't spamsum'd twice
:0 Wc
| /usr/local/bin/spamsum -T25 -d emailtmp/spamsum_scores -C -
# 'a' means the previous recipe ran successfull. ie, this message is similar
# to a previously found spam in the spamsum score. So, we pull it now.
:0 a
emailtmp/spampotcaught.d
:0
{
# if the message wasn't previously caught as being spam, then let's
# mark it as potential spam now with spamsum scoring :)
:0 c
| /usr/local/bin/spamsum - >> emailtmp/spamsum_scores
# and since it's a spampot, we save it seperate for now (for testing)
:0
emailtmp/spamsumcache.d
}
# note that all deliveries could be to /dev/null as all messages are assumed to be spam.
# safer will be to remove old messages from the caches after a short period (week?)
Thoughts / TODO
- Our test filter only determines is a spam is similar to a previously scored email. We don't know how similar. ie, we don't know how much our effectiveness would change with a different score.
- Test this by running every spampot message over the spamsum_scores and analysing scores resulting (will all be greater than the score in the procmail config.
- Test also the spamsum cache messages to see how many we could be saving? (for each message in the cache, generate a spamsum, then grep -v that out from the spamsum_scores file (so we don't get a perfect match) and generate a spamsum similarity score. Analyse...
- Check the spampot results for the timeframe that similar emails show up. (graph subject lines against dates?)
- Greater efficiency: spamsum as a daemon
- Different type of use: could the algorithm be altered to produce a hash which can validate partial messages. That way if a message was 50% recieved, but already was matching 100% score for that amount of data, we could close the connection early? (would development and in-use resource overhead be worth it just to move the scoring to the SMTP "DATA" phase?
- test spamsum memory and CPU usage over
- LARGE files
- LARGE spamsum_scores dataset (say with 1000, 10,000, 100,000 results precomputed)
- Both the above at once
- Expectation: that memory will always be low (spamsum does not have to hold the entire file in memory to generate the spamsum?), CPU will get relatively high (yay data processing), and throughput will be limited by disk IO. (when run through procmail, the file is piped in - from disk or from ram?)
- Is a spampot even nescessary? Couldn't this simply be run on a complete email dataset? Afterall, it works by allowing through the first instance of every unique email anyway, and ham tends to be relatively unique, whilst spam tends to come in repetitive sets...
- Yes... in simple testing, simply quoting an email in response makes it quite dissimilar, and their reply (which will be the next that spamsum sees) will have two levels of reply! (TODO: get numbers)
- TODO: test simply by feeding a weeks corpus of ALL my regular email through spamsum, simulating this.
- Do this twice: Once naively, once with pre-learnt spamsum_scores from the spampot
- Expectation: this will be effective, except possibly for email memes. (if the same funny picture is sent to you twice, even by different people, they will be base64 encoded the same and thus show up as being EXTREMELY similar.
Links
Further spam reading here:
- A plan for Spam - Paul Graham
- http://www.acme.com/mail_filtering/ - This guy is the God of spam filterers
- http://code.google.com/p/pyspamsum/ - This is the version of spamsum I use (though I don't use the python wrapper)
- http://www.samba.org/ftp/unpacked/junkcode/spamsum/ - Tridge's original spamsum
